Please use the following link to add a question.

Modeling friction

  • Asked in:
  • Asked By tribonet
  • Asked on August 14, 2017

Does anyone know why graphene reduces wear?

  • Asked in:
  • Asked By tribonet
  • Asked on August 14, 2017

Power spectrum of rough surfaces

coefficients of kinetic and static friction

  • Asked in:
  • Asked By Andrew Moka
  • Asked on November 16, 2018

1 Comment

  1. Hi
    I did ask this recently (before I had registered, so may not have been listed). If here twice; my apologies (but I cannot see it).
    Here goes:
    It is probably very simple, and answer is probably ‘NO!’ but, just in case there are any helpful pointers.
    Storing shotgun barrels. These are usually oiled with preservative oil of some sort after cleaning.
    This oil tends to run down the bores and gets into gun stocks via firing pin holes. This discolours the wooden stock and, ultimayely, also rots the wood.
    The easy answer (as I deploy) is to store barrels down. But a lot of owners do not like doing this.

    IS there any type of metal preservative oil (or light grease) that can defy the laws of Gravity and remain in place (so as not to run down the bores?)

    The principle may apply to others seeking to protect tubes stored vertically but in this case it is sporting shotgun barrel protection I am most concerned with.
    Any help, advice, suggestions or pointers very much appreciated.
    Regards. Richard Atkins

Leave a Reply

Your email address will not be published.


*


This site uses Akismet to reduce spam. Learn how your comment data is processed.

Skip to toolbar